When replacing a submersible well pump, the terms four-inch and six-inch usually describe nominal product size classes. They do not, by themselves, determine capacity, motor horsepower or whether a pump will fit a particular well. An appropriate selection must account for the installed casing, required water flow, pumping level and control system.

Start With the Well’s Actual Inside Diameter

A pump must physically fit within the well casing while allowing the clearances required by the manufacturer and installer. Nominal casing size, casing material, straightness and existing equipment can affect the effective space available. Never assume a nominal four-inch pump fits every nominal four-inch well without checking actual dimensions and installation requirements.

Determine the Flow and Total Dynamic Head

Water supply demand is measured at the fixtures, process or irrigation system. A well pump needs to deliver the required GPM while overcoming pumping-water level, elevation rise, delivery pressure and friction losses. Compare the required operating point with a specific manufacturer’s flow-head curve. The greatest published flow on a marketing label is not necessarily available at your required pressure.

How the Motor and Controls Affect Selection

Submersible motors have electrical and installation requirements that should be checked as a system. Verify voltage, phase, supply capacity, motor rating, cable length, starting equipment and protection. A variable-speed control system adds further motor and drive compatibility requirements. The selected pump and motor must be confirmed as a compatible assembly.

Other Conditions That Matter

Manufacturer Product Families

Industrial Pump Source covers Franklin Electric FPS 3200, FPS TRI-SEAL, six-inch TRI-SEAL, Grundfos SP and relevant Myers and Berkeley well-water equipment. Manufacturer literature governs exact model suitability.

Frequently Asked Questions

Will a six-inch pump always produce more water?

No. A specific pump’s stages, hydraulic design, speed and operating conditions determine capacity. The diameter classification alone does not establish the duty point.

Can I use the old motor with a different pump end?

Only when the manufacturer confirms the motor and pump are compatible and the installation requirements are met. A nameplate photograph of both assemblies helps.

Further reading: See our water well pump catalog, Franklin Electric guide, and pump selection guide. Send your well specifications for a quote.