Choosing an irrigation pump involves more than matching the motor’s horsepower. The pump has to deliver enough water at the pressure required by sprinklers, drip systems or agricultural distribution equipment. Gallons per minute (GPM), total dynamic head (TDH), water source and suction conditions determine which hydraulic pump is suitable.
Step 1: Identify the Flow Your Irrigation System Needs
For each irrigation zone, add the required flow rates of the sprinklers, emitters or other outlets running at the same time. Work from the largest expected zone demand, while accounting for possible future expansion. A system requiring 100 GPM should be matched to a manufacturer pump curve that delivers 100 GPM at the required head—not at an arbitrary pressure.
Step 2: Determine Total Dynamic Head
TDH includes the pressure required at the irrigation equipment, changes in elevation, suction-side conditions and friction losses through piping, valves and filters. Calculate using consistent units. Pressure can be expressed as feet of water when comparing against a pump performance curve; for water near ordinary temperatures, approximately 2.31 feet of head equals 1 psi.
Step 3: Decide Between Surface and Submersible Pumps
Surface-mounted centrifugal pumps can work where water can reach the pump inlet under suitable suction conditions. Self-priming centrifugal pumps provide configurations designed to regain prime under manufacturer-defined conditions. Where water levels are deep or suction lift is impractical, a submersible turbine pump may be preferable. Verify the actual water level under pumping demand, not just static water level.
Step 4: Check Suction Design and Cavitation Risk
Long undersized suction lines, excessive suction lift, trapped air and elevated liquid temperatures can reduce available suction head. A pump can cavitate if the net positive suction head available (NPSHa) is inadequate for the pump’s required NPSH at the operating point. Always refer to the manufacturer’s suction and installation guidance before final sizing.
Step 5: Review Manufacturer Pump Curves
For a candidate pump, locate the required GPM along the horizontal axis and the required total head on the vertical axis. Review the specific model’s impeller size, operating speed, efficiency, power requirement and NPSH data. Compare only models suitable for the water characteristics and installation. Check the current Berkeley manufacturer pump information when evaluating Berkeley equipment.
Which Irrigation Pump Brands Should You Compare?
Our catalog includes Berkeley close-coupled centrifugal, Berkeley frame-mounted centrifugal, Berkeley self-priming, Berkeley 6TMH turbine and Myers Quick Prime pump families. The best choice depends on the application and verified manufacturer curves—not a blanket brand ranking.
Frequently Asked Questions
Can I buy an irrigation pump by horsepower alone?
No. Horsepower reflects motor capacity; pumps with the same motor rating may produce very different flow and head. The correct duty point and pump curve are essential.
Do I need an irrigation pump that is self-priming?
Only if the installation requires self-priming behavior and the selected model is rated for the conditions involved. A properly flooded suction installation may not need that feature.
Request an irrigation pump quote: Send required GPM, TDH, water source, voltage, piping details and ZIP code through our industrial pump quote form, or call 517-278-2611.